CAN BUS Diagnosis online training

Once the course is finished, you can see it as many times as you want in the “My Courses” menu. This way you can refresh the knowledge when you need it.

Index:

1. Introduction.
2. What is the CAN BUS.
   • Components and operation High Speed CAN.
   • Components and operation Low Speed CAN.
   • Gateway.
     • What is the Gateway.
     • CAN without Gateway.
     • CAN with Gateway
3. CAN BUS Breakdown.
   • Identify a fault in the CAN.
4. Waveforms.
5. Identify the fault place in the wiring.
6. Test.

Methodology:

Noise Diagnosis is a microcourse made up of 3 lessons and 1 evaluation test, with a total duration of 90 min.

In each lesson you can find the teaching video and additional information. You can do each lesson independently, whenever you want and at your own pace, but don’t forget to click on the “Complete Lesson” button when you finish it, in this way it is registered as finished and will allow you to continue with the next one when you return to Diagnosis Tips.

Goals:

1. Know and understand the structures of the CAN BUS.
2. Perform terminal resistance measurements and determine if there is a fault on the CAN lines.
3. Identify the fault area by measuring terminal resistances.
4. Perform measurements on vehicles with multiple CAN BUS and Gateway.

Evaluation:

The evaluation consists of a multiple choice exam of 10 questions with a maximum of 3 attempts. At the end you can access the review where you will find the explanation of each question.

Diagnosis Tips reserves the right to limit the access time to the courses at any time, always by prior communication to the enrolled students.